21
R7 EXPERT / PRO SERVICE GUIDE
NOTICE
NOTICE
6b
Tightly thread a shock pump to
the comp rod end tting and ll
to desired air spring pressure,
occasionally pulling the casting
away from the CSA as air is
added. The recommended starting
pressures are shown in the charts
on the next page. Remove the
shock pump and clean the fork with
isopropyl alcohol.
COMPRESSION DAMPER INSTALL
NOTICE
Lightly pulling the casting away
from the CSA during air ll ensures
full extension of the fork and
proper air spring performance.
7
8
*EXPERT MODEL* Install the knob
seal and adjuster knob. Holding
the knob steady, use a 2mm hex
wrench and torque wrench to
assemble the knob screw (rotating
clockwise) and tighten to 0.5-0.7 in
lbs [4-6 N m].
*PRO MODEL* Install the open-
mode-adjust knob. Holding the
knob steady, use a 2mm hex
wrench and torque wrench to
assemble the knob screw (rotating
clockwise) and tighten to 0.5-0.7 in
lbs [4-6 N m].
For Expert, skip to step 7
For Pro, Skip to Step 8
To Next Page
Loading...
Need help?
General
