34 Part Number 000014141 Rev 11 12/23
Installation Section 2
Step 7 Insulation for the Suction Shutoff
Valve.
The insulation for the suction shutoff valve
is located in the plastic bag taped to the
water curtain.
Step 8 Ice Beverage Models Only.
The thermostat probe must be moved from
the shipping position to the ice-making
position.
• The bin thermostat probe must be
rotated down to enable ice contact and
proper operation.
• Verify probe wire does not interfere with
the water curtain.
• The control is preset and does not
require programming.
1. Loosen thumbscrew securing probe.
2. Rotate the probe from horizontal to
vertical position.
3. Tighten thumbscrew to secure probe.
Starting the Ice Machine
Starting the ice machine and completing
the Operational Checks are the
responsibilities of the owner/operator.
Adjustments and maintenance procedures
outlined in this manual are not covered by
the warranty.
REMOVE ICE THICKNESS PROBE
SHIPPING BRACKETS
Remove and discard shipping brackets
before starting the ice machine.
Step 5 Ice machine must be programmed
refer to “Setup Wizard” on page 41 for
details.
Step 6 Refer to “De-scaling and
Sanitizing” on page 47 and de-scale and
sanitize the ice machine and bin before
placing in operation.
Step 7 Refer to “Ice Making Sequence of
Operation” on page 43 for operational
details.
MINIMUM/MAXIMUM SLAB WEIGHT
Adjust ice thickness to maintain the correct
bridge thickness and “Minimum/Maximum
Slab Weight” on page 45.
To Next Page
Loading...
Need help?
General