On completion the start up screen is displayed showing the
updated firmware versions followed by the pre-heat temperature
screen.
Confirming the firmware update
After an update of the appliance firmware certain files are copied back to the USB memory stick.
You can check if the file transfer was successful with the following procedure:
1.
Load the files from the USB memory stick to a computer.
2.
Open the update (UPDATE.txt) file.
3.
A firmware update is confirmed below the serial number of the appliance with ‘updated’ following the
QTS/SRB firmware.
Load only the specific files for the stage 3.1 upgrade onto the USB memory stick:
BTS/QTS - (model type) V.003.000.001
SRB - (model type) V.003.000.001
Latest menu file xxxxxxxxxx
NOTE:
Load only the correct menu files onto the USB memory stick and not single menus.
To Next Page
Loading...