Perform the tests of your microwave combination oven as de-
scribed.
See “Tests” section of this manual.
If required refer to the “Replacing components” section for any
repairs needed before continuing with the tests.
5.
Follow the procedures under “Commissioning the appliance”
before commissioning your appliance for use.
9.2 Errors and diagnostics
Error messages
A description of the type of error is shown.
Check for a number following ‘ERROR:’ and refer to the error
codes (“Fault Finding” section of this manual) for more details.
The serial number of the oven, model, UI (QTS) version and SRB
version information are also displayed below.
2.
Clear the error message by power cycling the mains power
supply to the oven (not the oven ON/OFF switch).
To Next Page
Loading...