Tools required
Two metal pins (length: 10 mm / 0.4 in)
M5.5 hex socket wrench
M8 hex socket wrench
Requirements
Check that the following requirements have been met:
The appliance has been disconnected from the power supply and protective measures have been
taken to ensure the power cannot be switched on again.
The appliance is cool.
The high voltage capacitors are discharged before commencing work.
Anti-static precautions have been taken.
Removing components of the door assembly
Insert one suitable metal pin (length: 10 mm / 0.4 in) per door
hinge into the corresponding holes marked up in the image to lock
the door hinge.
Ensure the pins remain in this position until the door is fitted to the
oven again.
To Next Page
Loading...