Manitowoc Merrychef eikon e2s - Page 168

12 Replacing components
eikon e2s Service and Repair Manual UL 168
3.
Slacken the pivot screw using a M7 hex socket wrench.
4.
Release the adjusting screws and move the backplate until
microswitch SW3 just activates. Then secure all screws.
5.
Open the appliance door to replace the green 2 mm spacers with
red 4 mm spacers and close the door.
6.
Slacken the pivot screw.
7.
Release the adjusting screws and move the backplate until
microswitch SW2 just activates. Then secure all screws.
8.
Remove the spacers, then open and close the appliance door
5-10 times.
IMPORTANT:
Check if the switches operate in the following sequence as microswitch SW3 must switch the load
current.
Closing the door:
 SW1 opens first
 SW2 closes second
 SW3 closes third
oven door open
Opening the door:
 SW3 opens first
 SW2 opens second
 SW1 closes third
oven door closed