Identify ten screws fixing the plate carrying the convection fan
motor to the rear of the cavity.
There are three screws close to the horizontal edges and two
screws close to the vertical edges.
Carefully cut the tape covering the insulation mat with a knife to
access the screws.
Unfasten ten M7 hex head flange bolts to remove the plate with
the convection fan motor.
CAUTION:
Wear personal protective equipment to protect your fingers when
using the knife.
NOTE:
The exhaust pipe is also connected to the rear plate. Be careful
not to damage it when lifting out the plate.
2.
After replacement carefully refit all screws following the instruc-
tions given above.
Restore the tape sealing using heat-resistant tape recommended
by the manufacturer.
To Next Page
Loading...