1.Lift the rear tailstock to reach the
installation stroke of the rear shock
absorber.
2. Align the front end of the shock
absorber with the fixing hole slot of
the frame, and screw in the fixing
bolt from the left side to the bottom.
3.Align the shock absorber with the
mounting hole slot of the frame, and the
fixing bolt passes through the bottom
from the left side. Coat the upper and
lower damping nuts with thread sealant.
13 # open-end wrench is used for the left
bolt, and 14 # open-end wrench is used
for the right nut to lock.
Warning:The fixing nuts of shock absorbers shall be coated
with thread sealant, and the bolts and nuts shall be locked
with a tightening torque of 40-45N. m.
To Next Page
Loading...