11
、
Maintenance Guide
In principle, with normal riding, you can do the first check at 10~30Km (can also be
understood as the first warranty).
Inspection content.
1. front and rear wheel wire spokes tightness.
2. whether there is a gap in the front steering column bearing.
3. chain tightness check.
4. Tension wheel check (whether the chain is in the tension wheel guide groove).
5. Check whether the shock absorber is leaking oil and whether the compression and
rebounds are in the correct position; (Note: Do not screw the adjustment knob to the
left or right in the adjustment process).
6. Check the tightness of the screws fixing the handlebars.
Special Note: Be sure to turn the power off before starting any maintenance.
Pay full attention to safety when checking.
1. choose a wide and flat place and park the vehicle.
2. when it is necessary to drive for the inspection, do it in a safe place while paying
attention to the surrounding environment and situation.
3. If the inspection finds any abnormality, please only drive after eliminating the
abnormality, and if you cannot solve the problem by yourself, please contact the
after-sales service or designated authorized service outlet.
Note
1. front and rear brakes are disc brakes. The brake friction pad should be replaced
before it becomes seriously worn.
2. Pay attention to the cleanliness of the disc brake system in daily use to avoid
prolonged adhesion of mud and sand, especially to avoid oil pollution.
To Next Page
Loading...
Need help?
General