6、Vehicle use instructions
P-gear parking function
1、Enter P-gear parking at power-on.
2、Automatically enter P-gear parking after the vehicle is stationary for 10 seconds.
3、Enter P-gear parking when the side bracket is supported.
Note: Make sure the side bracket is open before you pinch the brake to lift the P-gear parking
function!
Vehicle "power off" (power on but lose power)
1. Brake power off: pinch the brake handle, and turn the speed control handle, which will
have no power output.
2. Motor overheating protection.
3. Controller overheating protection.
4. Battery overheating and power reaches the under-voltage protection point.
Vehicle power reduction
1. Controller overheating (when the working temperature exceeds 85 ℃, begins to enter the
derating process; each 1°increase will derate by 10%. If it continues overheating down to 20% of
the rating, the power output will be cut off. It can be used again after the controller has cooled).
2. Motor overheating (when the working temperature exceeds 110℃, it starts to enter the
derating process, each increase of 1°will increase derating by 10%. If continued overheating,
down to 20% of the rating power output will be cut off. Wait for the motor to cool down, and then
it can be used).
3. Voltage from 53V to start linear derating processing, each lower 1V, reduces the amount
of 20%, the minimum drop to 15% of the rated.
4. When the power is zero, stop the power output. (If it is not charged in time to continue to
be used, the battery may enter over-discharge protection.)
Note: After over-discharge protection, the battery needs to be charged and activated with the
charger. For the activation method, see the P35 fault phenomenon, Article 7.
About the environment during use
1. Using the sports gear is not recommended if the temperature is lower than 0℃ ~ -20℃, the
battery is equivalent to 80% of room temperature.
2. It is recommended not to ride at full power for a long time when the temperature is higher
than 50℃.
To Next Page
Loading...
Need help?
General