Battery check
1. Check the power
The bike uses a sealed ternary lithium battery. Check the battery needs to be full, and
then use a multimeter to measure the positive and negative voltage of the electric port.
The full voltage should be between 66.2 ~ 67.2V for normal operation.
2. Check the appearance of the battery
Check if it is damaged. For example, if the battery's upper and lower sealing covers
and power indicator break, it will lead to the risk of water after the seal failure. Then
please contact the aftermarket or designated authorized service outlets.
Note.
1. close the switch lock and air switch before taking and installing the battery, cover
the charging port sealing rubber cap.
2. If you find that the battery cannot be put into the battery compartment, please do
not force it in. Remove the battery to check whether the battery is stuck due to foreign
objects.
3. winter battery storage, it is recommended that the battery is stored indoors, with
temperature conditions above 0 ℃. Also, regularly check the power.
Battery charging and charger use
1. The dirt bike must be charged with the original model compatible charger. Do not
use other models that do not match the charger so as not to damage the battery or
be dangerous.
2. Check whether the charger input voltage is consistent with the grid voltage.
3. The charger will automatically turn off when it is fully charged, but try to avoid
To Next Page
Loading...
Need help?
General