o
Distance FL / Distance FR
Set distance from main listening position to speaker.
0.0 ft – 60.0 ft (Default: 12.0 ft) /
0.00 m – 18.00 m (Default: 3.60 m)
0
Set the difference in the distance between the speakers to less than 20.0 ft
(6.00 m).
o
Level FL / Level FR
Adjust the level of each channel.
-12.0 dB – +12.0 dB (Default: 0.0 dB)
Tactile Transducer Setup
Set the level and low pass filter cutoff frequency when using tactile
transducers.
o
Tactile Transducer
Sets the tactile transducer option.
Enabled: Enables tactile transducers.
Disabled
(Default):
Disables the tactile transducers.
0
For Tactile Transducer connections, use the Subwoofer 4 PRE OUT
connector.
0
This can not be set when “Speaker Configuration” - “Subwoofer” is set to “4
spkrs”.
o
Level
Adjusts the volume of the tactile transducer output.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0
The “Level” are reflected in all input sources.
0
If you wish to adjust the tactile transducer level for each input source, carry out
the settings in “Tactile Transducer”. (v p. 133)
Contents Connections Playback Settings Tips Appendix
241
Front panel Display Rear panel Remote Index
To Next Page
Loading...
