z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z3
The applicable sound mode includes “DTS Virtual:X” and sound modes that have “+Virtual:X” in the sound mode name.
z4 Audio is output when “Bass” - “Subwoofer Output” in the menu is set to “LFE + Main”. (v p. 237)
z5
A signal for each channel contained in an input signal is output as audio.
z6
Audio is not output when the “Surround Parameter” - “Speaker Virtualizer” in the menu is set to “On” and “Speaker Configuration” - “Surround Back” in the menu is set to
“1 spkr”. (v p. 177, 230)
z7 Audio is not output when the “Surround Parameter” - “Speaker Virtualizer” is set to “On”. (v p. 177)
z8
When “Speaker Configuration” - “Surround Back” is set to “2 spkrs”, “Speaker Configuration” - “Center” is set to “Large” or “Small”, and sound mode is set to “IMAX DTS”,
surround audio is output from the surround back speaker. Audio is not output from the surround speaker. (v p. 230)
z9
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z10
For the best Auro-3D experience Front Height and Surround Height speakers are recommended, however you may substitute Dolby Atmos Enabled speakers.
z11 Audio is output from the speakers specified in the “Surround Parameter” - “Speaker Select” settings. (v p. 180)
Contents Connections Playback Settings Tips Appendix
306
Front panel Display Rear panel Remote Index
To Next Page
Loading...
