5.1ch (Bi-Amp):
Setting to use the front speakers via the bi-
amp connection.
5.1ch + Front B:
Setting for playback using a second front
speaker. You can switch the playback
between front speaker A and B according
to your liking. Switch the front speaker
using “Front Speaker” in the menu.
(v p. 202)
Preamplifier:
0
All of the speakers are connected using
an external power amplifier and this unit
is used as a preamplifier.
o
Front/Center/Surround/Surround Back
Set the correct audio output terminals for your speaker system.
n
Configuration
Select whether or not each speaker exists. For Surround Back
speakers, select the number of speakers to be used.
[Front/Center/Surround]
Yes
(Default):
The selected speakers will be used.
No: The selected speakers will not be used.
[Surround Back]
2 spkrs
(Default):
Two Surround Back speakers will be
used.
1 spkr:
Only one Surround Back speaker will be
used. When you select this setting,
connect to the SURROUND BACK L
terminal.
No: Surround Back speakers will not be used.
0
“Front” is fixed as “Yes” as it is required for playback.
0
When “Surround” is set to “No”, “Surround Back” settings are automatically set
to “No”.
0
“Surround Back” can be set when Amp Assign is set to “7.1ch”.
0
Surround Back speakers cannot be used when using “Height” speakers.
Contents Connections Playback Settings Tips Appendix
194
Front panel Display Rear panel Remote Index
To Next Page
Loading...
