n
Connection
Select the output terminals for audio from the speakers.
Spkr + Pre-out
(Default):
Speaker and pre-out outputs are active.
Pre-out Only:
Pre-out outputs are active. Speaker
outputs are disconnected for enhanced
audio quality using only the pre-out
terminals.
0
When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all
speakers will be fixed as “Pre-out Only”.
o
Height
Height speakers can be used with the Surround Back terminal.
n
Configuration
Set the speaker layout when installing 1 set (2-channels) of Height,
Ceiling or Dolby Atmos Enabled speakers.
Front Height: Front Height speakers are used.
Top Front: Top Front speakers are used.
Top Middle: Top Middle speakers are used.
Front Dolby: Front Dolby speakers are used.
Surround Dolbyz:
Surround Dolby speakers are used.
No: Height speakers are not used.
z
This can be selected when using Surround speakers. Set “Surround” in the menu
to “Yes”. (v p. 194)
0
Can be set when “Amp Assign” is set to “7.1ch”.
0
Cannot be set when Surround Back speakers are being used.
Contents Connections Playback Settings Tips Appendix
195
Front panel Display Rear panel Remote Index
To Next Page
Loading...
