Levels
Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
o
Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0
The set “Levels” are reflected in all sound modes.
0
If you wish to adjust the channel level for each input source, carry out the
settings in “Channel Level Adjust”. (v p. 115)
0
When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
o
Set Defaults
The “Levels” settings are returned to the default settings.
Crossovers
Set in accordance with the lower limit frequency of the base frequencies
that can be played back through each speaker. See the speaker manual
for information concerning speaker crossover frequency.
o
Set the crossover frequency
Full Range:
Select “Full Range” to set the speaker to
play full-range audio.
40 Hz / 60 Hz / 80 Hz /
90 Hz / 100 Hz / 110 Hz /
120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz
(Default: 80 Hz)
Selects the crossover point to send the
low frequency sound to the subwoofer.
0
The default crossover frequency is “80 Hz”, which will work best with the
widest variety of speakers. We recommend setting to a higher frequency that
the crossover frequency when small speakers are used. For example, set to
“250 Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.
0
Sound below the crossover frequency is cut off from the output of the
speakers. This cut off bass frequency is output from the subwoofer or front
speakers.
0
The “Front” is automatically set to “Full Range” when “Subwoofer” is set to
“No” in the “Speaker Layout”.
0
Each speaker can be set to “Full Range” only when the Front is set to “Full
Range”.
Contents Connections Playback Settings Tips Appendix
199
Front panel Display Rear panel Remote Index
To Next Page
Loading...
