Connecting to a WPS network
0
If your wireless router support WPS (Wi-Fi Protected Setup™) this unit can optionally connect to your network using the “Push Button” method by
following these steps:
Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the CONNECT button on the rear panel of this unit for 5 seconds.
3. The LED on the front of this unit will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of this unit will turn solid Green.
Resetting this unit
0
Resetting this unit will clear out the wireless network info, EQ, and name but retain it’s current software. You will have to use Settings - Add Device to
reconnect this unit to your home network before it can be used.
To reset this unit, press and hold the CONNECT and Bluetooth (V) buttons located on the back of this unit for 5 seconds until the front LED begins to
flash amber.
The HDMI control function does not work
The HDMI control function does not work.
0
You cannot operate devices that are not compatible with the HDMI control function. In addition, depending on the connected device or the settings, the
HDMI control function may not work. In this case, operate the external device directly.
0
Check that the HDMI control function setting is enabled on TV connected to this unit.
Contents
Setup Playback Troubleshooting Status LED Appendix
34
To Next Page
Loading...
