Marantz NA8005 - Page 83

o
Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
(v
p. 21)
1
Press USB-DAC to switch the input source to “USB-
DAC”.
Start playback on the computer’s player software.
The digital audio signal that is being input is shown as follows in the
display.
“USB-DAC:
or
“USB-DAC:
PCM xxxx kHz” DSD xxxx MHz”
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
o
Files that can be played back
See “D/A converter” (v p. 110).
NOTE
0
Perform operations such as playback and pause on the computer. At this time, you
cannot perform operations with buttons on this unit or the remote control.
0
You can also control the volume and equalizer on the computer. Enjoy playing
music at the desired volume.
0
When this unit is functioning as a D/A converter, sound is not output from the
computer’s speakers.
0
If the computer is disconnected from this unit while the computer music playback
software is running, the playback software may freeze. Always exit the playback
software before disconnecting the computer.
0
When an abnormality occurs on the computer, disconnect the USB cable and
restart the computer.
0
The sampling frequency of the music playback software and sampling frequency
displayed on this unit may differ.
0
Use a cable that is 3 m or less to connect to the computer.
Contents
Connections Playback Settings Tips Appendix
83
Front panel Rear panel
Remote control
unit
Index