What to do if my Marantz Stereo Receiver is displaying 'Overcurrent'?
If your Marantz Stereo Receiver is displaying 'Overcurrent', it means the USB memory device is consuming too much power. If you're using a USB portable hard disk that can be powered by an AC adapter, connect its AC adapter.
How to resolve reception issues with my Marantz Stereo Receiver?
If you're experiencing reception failures, noise, or distortion with your Marantz Stereo Receiver, try changing the antenna orientation or position. Separate the AM loop antenna from the unit and consider using an FM outdoor antenna. Also, keep the antenna separate from other connection cables.
How to fix no audio output with HDMI connection on Marantz Stereo Receiver?
If you're experiencing no audio output with an HDMI connection on your Marantz Stereo Receiver, check the connection of the HDMI connectors. When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “Amp.” When outputting HDMI audio from a TV, set “HDMI Audio Out” on the menu to “TV.”
What to do if my Marantz Stereo Receiver is not displaying the on-screen display or noise occurs?
If the on-screen display is not shown or noise occurs on your Marantz Stereo Receiver, set the on-screen display output mode to match your TV and connection method.
How to fix 'Not Support' message on Marantz Stereo Receiver when using iPod?
If your Marantz Stereo Receiver displays 'Not Support' when an iPod is connected, the iPod may not be compatible. Ensure the iPod you are connecting is compatible. Also, if the software version of the connected iPod is old, update it to the latest version.
General| Channels | 7.1 |
|---|---|
| HDMI Inputs | 4 |
| HDMI Outputs | 1 |
| 3D Support | Yes |
| Audio Return Channel (ARC) | Yes |
| Audio Formats Supported | Dolby TrueHD, DTS-HD Master Audio |
| Audyssey MultEQ | Yes |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200 mV |
| USB Port | Yes |
| AM/FM Tuner | Yes |
| Bluetooth | No |
| AirPlay | No |
| Power Output | 50W per channel |
| HDMI Version | 1.4a |
| Signal-to-Noise Ratio | 100dB |
To Next Page
