Need help?Do you have a question about the Marantz PM-12 SE and is the answer not in the manual?
General| Power Output (8 ohms) | 100 W |
|---|---|
| Frequency Response | 5 Hz - 50 kHz |
| Signal-to-Noise Ratio | 100 dB |
| Input Impedance | 47 kΩ |
| Weight | 21.5 kg |
| Input Sensitivity (MM) | 2.5 mV |
| Input Sensitivity (MC) | 0.3 mV |
| Signal-to-Noise Ratio (MM) | 85 dB |
| Signal-to-Noise Ratio (MC) | 75 dB |
| Input Sensitivity | 200 mV |
| Damping Factor | 100 |
| Power Output (4 ohms) | 200W |
Identifies and explains the various controls and indicators located on the front panel of the amplifier.
Identifies and explains the connectors and controls found on the rear panel of the amplifier unit.
Step-by-step guide for safely connecting speaker cables to the unit's speaker terminals.
Solutions for issues related to the unit not powering on or turning off unexpectedly.
Troubleshooting steps for problems encountered when operating the unit via the remote control.
Guidance on resolving issues where no sound is produced by the speakers.
To Next Page
