Why is sound coming from the wrong channel on my Marantz SR4300?
If the sound from your Marantz Receiver is coming from the wrong channel, the speaker cable might be connected incorrectly. Refer to the connection diagram to ensure the cable is properly connected.
Why can't I select EX/ES mode on my Marantz SR4300 Receiver?
If you cannot select EX/ES mode on your Marantz Receiver, ensure that 'Surround back = NONE' hasn't been selected in the SPEAKERS SIZE SETUP. Also, make sure you are using a 5.1 channel source.
Why can't I select Pro Logic II mode on my Marantz SR4300?
If you cannot select Pro Logic II mode on your Marantz Receiver, it's likely due to an incompatible input signal. Use a 2 channel Dolby Digital input signal, PCM input signal, or analog input signal.
General| Frequency Response | 10 Hz - 100 kHz (+1, -3 dB) |
|---|---|
| Signal to Noise Ratio | 98 dB |
| HDMI Inputs | 0 |
| Component Video Inputs | 2 |
| Digital Audio Inputs | 2 Optical, 1 Coaxial |
| Type | AV Receiver |
| Surround Sound Formats | Dolby Digital, DTS, Dolby Pro Logic II |
| Total Harmonic Distortion | 0.08% |
| Tuner Section | AM/FM |
| Analog Outputs | 2 |
| Input Sensitivity | 200mV |
| Video Inputs | 2 S-Video |
| Video Outputs | 1 S-Video |
To Next Page
