Trigger Out
Select the conditions for activating trigger out.
For details about how to connect the TRIGGER OUT jacks, see “DC OUT
jack” (v p. 55).
n
When setting for zone (MAIN ZONE/ZONE2)
Trigger out is activated through linkage to the power of the zone set to
“On”.
n
When setting for input source
Trigger out is activated through linkage to the power of the zone set to
“On”.
It is valid for the zone, which is set to “On” and “When setting for zone”.
n
When setting for HDMI monitor
Activate trigger out when the HDMI monitor set to “On” is selected.
On:
Activate trigger on this mode.
– – –: Do not activate trigger on this mode.
Front Display
Makes settings related to the display on this unit.
o
Dimmer
Adjust the display brightness of this unit.
Bright
(Default):
Normal display brightness.
Dim: Reduced display brightness.
Dark: Very low display brightness.
Off: Turns the display off.
You can also adjust the display by pressing DIMMER on the main unit.
Contents Connections Playback Settings Tips Appendix
200
Front panel Display Rear panel Remote Index
To Next Page
Loading...
