Marantz SR5011 - Audyssey

o
Power On Level
Define the volume setting that is active when the power is turned on.
Last
(Default):
Use the memorized setting from the last
session.
Mute:
Always use the muting on condition when
power is turned on.
1 – 98 (–79 dB – 18 dB) : The volume is adjusted to the set level.
0
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0
dB”. (v
p. 165)
o
Mute Level
Set the amount of attenuation when muting is on.
Full
(Default):
The sound is muted entirely.
–40 dB : The sound is attenuated by 40 dB down.
–20 dB : The sound is attenuated by 20 dB down.
Audyssey
®
Set Audyssey MultEQ
®
XT, Audyssey Dynamic EQ
®
and Audyssey
Dynamic Volume
®
. These can be selected after Audyssey
®
Setup has
been performed.
For additional information on Audyssey technology, please see
“Explanation of terms” (v
p. 266).
0
“MultEQ
®
XT”, “Dynamic EQ”, “Reference Level Offset” and “Dynamic Volume”
settings are stored for each input source.
0
When the sound mode is in the “Direct” or “Pure Direct” mode, “MultEQ
®
XT”,
“Dynamic EQ” and “Dynamic Volume” settings cannot be configured.
0
This cannot be set when the input mode is set to “7.1CH IN”.
Contents Connections Playback Settings Tips Appendix
166
Front panel Display Rear panel Remote Index