3-5. TUNER STEP mode (U / N only)
3-5.1. Actions
This is a special mode that enables the reception frequency STEP of the ANALOG TUNER to be changed.
3-5.2. Starting up
While holding down buttons "
ZONE2 SOURCE
" and "
STATUS
" simultaneously, press the power button
to turn on the power.
Select the "
5TUNER FREQ
" using the "
TUNER PRESET CH +/-
" button, then press the "
STATUS
"
button then to conrm.
3-5.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "
TUNER PRESET CH +-
"
button, then enter using the "
STATUS
" button.
The following information is displayed in the following order.
(1) AM9 kHz / FM50 kHz is selected
L1
TunerFRQ
L2
AM9/
L3
FM50
"
TUNER PRESET CH +
" "
TUNER PRESET CH -
"
(2) AM10 kHz / FM200 kHz is selected
L1
TunerFRQ
L2
AM10/
L3
FM200
"
STATUS
"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
140
To Next Page
Loading...
