Need help?Do you have a question about the Marantz SR5400 and is the answer not in the manual?
Audio Section| power output | 90W/ch (8 ohm) |
|---|---|
| signal to noise ratio | 105 dB |
| frequency response (analogue in) | 10Hz - 100kHz (+/- 3dB) |
| frequency response (digital in) | 8Hz - 45 kHz (+/- 3dB) |
| input sensitivity/impedance | 168mV / 47kohm |
Tuner Section FM| frequency range | 87.5 - 108 MHz |
|---|---|
| signal to noise ratio | 75 / 70 dB (mono/stereo) |
| distortion (mono/stereo) | 0.2 / 0.3 % |
| channel selectivity | 60 dB (+/-300kHz) |
| usable sensitivity IHF | 1.8uV / 16.4 dBf |
| channel separation | 45 dB (1kHz) |
Tuner Section AM| frequency range | 531-1602kHz (MW) |
|---|---|
| signal to noise ratio | 50 dB |
| distortion | 0.5% (400Hz 30% mod) |
| channel selectivity | 60 dB (+/-18kHz) |
Sound Enhancements| power transformer | EI |
|---|---|
| d/a conversion | 192kHz/24bit All Channel |
| a/d converter | 192kHz / 24bit |
| digital signal processing | 32bit |
| digital signal processor | CS49400 |
General| color | Black / Silver |
|---|---|
| remote control | RC5400SR |
| system remote function | Pre-Coded |
| maximum dimensions (w x d x h) | 440 x 160 x 463 mm |
In/Outputs| composite in/out | 5/3 |
|---|---|
| s-video in/out | 5/3 |
| component in/out | 2/1 |
| analogue in/out | 8/4 |
| digital optical in/out | 2/1 |
| digital coaxial in/out | 2/1 |
| pre-amplifier out | 6.1 channels |
| multi-channel in | 6.1 channels |
| speaker terminal | Heavy Duty Screw, 6 channels |
| ac outlets | 1 x Unswitched |
To Next Page
