Marantz SR7002 - Specific Commands

SR8002/SR7002 RS-232C Control Specification Page: 18 / 32
Document Version [1.00]
Company Restricted
This part is available for SR8002 only.
For Analog Tuner Model
Command Reply from Slave
VALUE “MTF=0xxxxx“ (xxxxx = freq.)
UP “MTF=1“
DOWN “MTF=2“
Auto-UP “MTF=3“
Auto-DOWN “MTF=4“
HD Auto-UP
（HD Radio Only）
“MTF=5“
Multi Room B
Tuner1 Frequency
HD Auto-DOWN
（HD Radio Only）
“MTF=6“
“MTF=xxxxx”
(xxxxx = Frequency)
if ( xxxxx < 00256 ) band =
XM;
else if (xxxxx < 02000)
band=AM;
else band=FM;
(ex.“08750” = FM87.50MHz)
*Auto-UP/DOWN dose not
operate in XM
*XM can be selected When Band
is XM.
VALUE
“MTP=0ww” (ww = preset
nr.)
UP “MTP=1”
DOWN “MTP=2”
SCAN Start “MTP=3”
Multi Room B
Tuner1 Preset
SCAN Stop “MTP=4”
“MTP=ww”
(ww = current preset nr.)
(ww = 01 ~??)
TOGGLE “MTM=0”
OFF(MONO) “MTM=1”
ON(AUTO) “MTM=2”
Multi Room B
Tuner1 mode
Digital Auto
（HD Radio Only）
“MTM=3”
“MTM=0”( - ),
“MTM=1”(MONO),
“MTM=2”(AUTO)
“MTM=3”(DigAUTO)
5-1-2. Specific Commands
Command from Host Reply from Slave
Auto status feedback
(The product default is disabled
all auto status feedback.)
“AST:x” (x = ‘0’ ~ ’F’)
bit 3 : Layer 4 ( 1 = Enable, 0 = Disable)
bit 2 : Layer 3 ( 1 = Enable, 0 = Disable)
bit 1 : Layer 2 ( 1 = Enable, 0 = Disable)
bit 0 : Layer 1 ( 1 = Enable, 0 = Disable)
same as
command define