o
Subwoofer
Set the presence of a subwoofer.
Yes
(Default):
Use a subwoofer.
No:
Select when a subwoofer is not
connected.
0
When “Speaker Config.”-“Subwoofer” in the menu is set to “None”, No is
automatically set. (v
p. 258) If the “Front” setting is “Small”, the setting is
automatically “Yes”.
o
SW Mode
Select low range signals to be reproduced by subwoofer.
LFE
(Default):
When “2ch Playback”-“Front” is set to
“Large”, only LFE signals are output from
the subwoofer. Also, when “2ch
Playback” - “Front” is set to “Small”, the
front channel low range signals are
added to the LFE signals and output from
the subwoofer.
LFE+Main:
The front channel low range signal is
added to the LFE signal output from the
subwoofer.
0
This can be set when “2ch Playback”-“Subwoofer” is set to “Yes”.
Contents Connections Playback Settings Tips Appendix
268
Front panel Display Rear panel Remote Index
To Next Page
Loading...
