Levels
Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
o
Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0
The set “Levels” are reflected in all sound modes.
0
If you wish to adjust the left and right balance for each input source, carry out
the settings in “Balance”. (v p. 102)
0
When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
o
Set Defaults
The “Levels” settings are returned to the default settings.
Advanced
o
Speaker Select
n
Speaker
Set the speaker A/B for every sound mode.
A
(Default):
Speaker A is used.
B : Speaker B is used.
A+B : Both speaker A+B are used.
Contents Connections Playback Settings Tips Appendix
152
Front panel Display Rear panel Remote Index
To Next Page
Loading...
