Marcy Fitness www.marcyfitness.co.uk
STEP 8 (See Diagram 8 & Cable Loop Diagram)
A.) Attach one end of the 246cm Sliding Weight Post Cable (#46) to the Rear Upper Frame
(#18). Secure it with one M10 x 2 3/8” Allen Bolt (#118), two Ø ¾” Washers (#107), and one
M10 Aircraft Nut (#110).
B.) Attach a Pulley (#62) to top holes on the two Double Floating Pulley Brackets (#33). Secure
the Pulley with one M10 x 2” Allen Bolt (#94), two Cable Retainers (#78), two Ø ¾” Washers
(#107), and one M10 Aircraft Nut (#11). Draw the Cable around the Pulley upward to the
opening on the Weight Glide Post (#17). Let the Pulley hanging for now.
C.) Attach a Pulley to the opening. Secure it with one M10 x 2 ½” Allen Bolt (#95), two Ø 1” x ½”
Pulley Bushings (#57), and one M10 Aircraft Nut (#110).
D.) Draw the Cable around the Pulley and then downward to the triangular bracket on Sliding
Weight Post (#23). Secure the end of Cable to the bracket with one M10 x ¾” Allen Bolt
(#90), two Ø ¾” Washers (#107), and one M10 Aircraft Nut (#110).
E.) Attach two Weight Post Olympic Sleeves (#68) onto the Sliding Weight Post. Attach a
Spring Clip to each Sleeve.
21
To Next Page
Loading...
