09
Fig. 03: Connect the waler pipe lo the waler inlet and water outlet connections,
please remember to install the rubber seal ring.
1. All water pipe must comply with national and applicable state and local water pipe
codes.
2. The unit should be connected directly to the main water supply. Flush pipe with
waler lo remove any debris or loose particles before connecting to the unit.
3. It is required that use 1/2"NPT water connections lo rrt the models of
EC045/EC085.
4. Please remember lo install rubber seal rings at the connections. When all water
connections are completed, check for leaks and take corrective action before
proceeding.
Electrical connections
1. All electrical work must comply with national and applicable state and local
electrical codes.
2. All units must be connected lo a properly grounded dedicated circuit of
proper voltage rating.
3. EC045 can be connected to a single-pole circuit, please use the supplied cable.
Outlet Inlet
Water connections
Fig. 03
To Next Page
Loading...
