1. Make sure the appliance is intact, and the ttings are complete.
2. Please make sure the main power supply, water pressure, grounding condition,
ammeter and wire reach the standard of installation requirement.
3. The appliance must be connected to properly grounded dedicated branch circuits of
proper voltage rating. Ground must be brought to the "ground" at the circuit breaker
panel.
4. This appliance MUST be permanently connected to the xed circuit breaker. If you do
not use the heater, please switch o the circuit breaker.
5. DO NOT install this appliance near tinder or a strong magnetic eld place. The unit
must only be assembled in a VERTICAL position near by the water ttings. Please try the
unit after getting the water ow.
PRODUCT INNER STRUCTURE
INSTALLATION GUIDELINE
Down
On/OFf
Up
Temp. Sensor
Heating Chamber
Flowmeter
Terminal blocks
L2
L1
E
Display Screen
Bottom Panel
Control Board
09
To Next Page
Loading...
Need help?
General
