05
DO NOT use a fuel gas that is not listed on the nameplate as compatible with the water heater.
Abnormal combustion or a deagration may occur which can cause a serious accident.
DO NOT use the unit if the vent piping has been damaged or altered in any way including
cracking, separation, rusting, melting, etc. Improper venting may cause a buildup of Carbon
Monoxide (CO) which can cause brain damage or death.
·If the water heater needs to be installed, moved, or serviced only utilize licensed professionals.
The use of professionals ensures all work is in full compliance with required building, plumbing
and electrical codes.
· Keep the area around the appliance clear and free of ammable materials such as cloth, wood,
aerosol cans, paper, gasoline, etc.
·When using hot water for a shower or bath always check the water temperature before entry to
avoid being scalded. Obey local codes for the maximum water temperature setting allowed.
Water temperatures over 125ºF (52ºC) can cause severe burns or death from scalds. Households
with small children, disabled or elderly persons may require a setting of 120ºF (49ºC) or lower.
·This heater is designed only for the heating of water and should not be used for other applica-
tions or used to heat any other media.
·Never use a fuel gas that is not listed on the nameplate as compatible with the water heater.
Abnormal combustion or a deagration may occur which can cause a serious accident including
damage to the heater.
·Do not use this appliance if any part has been under water. Consult a qualied service techni-
cian to inspect the appliance and make any required repairs prior to installation and operation.
·This water heater is designed for indoor mounting. Never mount it outdoors.
·This equipment should be installed in an area where water leakage from the unit or connections will
not result in damage. The manufacturer is not responsible for any damages resulting from leaks.
·Only connect gas and water as instructed. Incorrect or reversed connections will cause
equipment damage and will not be covered under product warranty.
·Do not over tighten connections or equipment may be damaged.
·Do not install in areas that are subject to vibration.
·This equipment shall not be operated without the vent pipe properly connected. The exhaust
pipe must not terminate in an area where the exhausting vapor or collecting condensate could
create a hazardous situation or cause property damage. Exhaust gases must be vented out of
the building in compliance with all building codes.
·The exhaust piping is very hot during and for a period after use. Do not touch the pipe.
·Ensure that snow, ice or other debris does not block the inlet or exhaust pipes.
·Regular housekeeping should be done in areas around the heaters to prevent insect
intrusion and possible equipment malfunction.
·The unit should be serviced on a routine basis to ensure optimum performance. Service needs
will vary based on local water conditions including acidity, alkalinity, hardness, etc.
·Freezing temperatures will cause damage to the heater. Install in locations where freezing temperatures
are not reached and follow procedures to drain the unit if it will be out of service for a period of time.
FREEZE DAMAGE IS NOT COVERED UNDER THE PRODUCT WARRANTY
1.3 SAFETY WARNINGS
To Next Page
Loading...
Need help?
General
