Marey Gas Models - Technical Specifications and Troubleshooting; Technical Parameters; Temperature Increase Chart

1716
16L units
IMPORTANT WARNING - PLEASE TAKE NOTE
If your unit is a 16L model, you MUST follow this diagram for correctly connecting
water and gas to the unit.
The water and gas connection diagram contained on the previous page accurate
only for the 5L and 10L Power Gas models. If you have a 5L or 10L unit, please
follow the diagram contained on the previous page.
Water inlet pipe
Gas inlet pipe
Hot water outlet pipe
Drawing 08
*With and without LCD panels.
Note: If your gas model features an LCD panel, the digital display will indicate the outgoing
water temperature.
This information is intended as a guideline based on typical residential environments.
Temperature increases will vary depending on the environment in which the heater is used.
Variables such as very low incoming water temperature or higher than average gas pressure
can result in higher temperature increases. Higher incoming water temperature or lower
than average gas pressure can result in lower temperature increases. ALWAYS test the
water with your hand to confirm suitable temperature before use.
Temperature increases listed are based on use of the water heater under optimal conditions
with an incoming water temperature of 48ºF. Variable factors such as incorrect or imperfect
installation or warmer incoming water temperature may yield different results.
* No need for electricity, starts with pulse ignition, powered by 2 D cell batteries.
Hot Water Outlet per Minute
Heat Loss
Exhaust Discharge Mode
Ignition
Energy Efficiency
Width x DepthHeight x
Weight
Aplicable Water Pressure
5 LPM / 1.3 GPM
34,614 BTU/h
11,4" x 4,7"17" x
11 lbs
10 LPM / 2.7 GPM
79,228 BTU/h
Flue Duct Type
54% - 87%
13,6" x 6,9"23,6" x
21 lbs
3.6 - 145.0 PSI / 0.25 - 10 bar
2D Cell Battery Powered (not included)
16 LPM / 4.2 GPM
111,903 BTU/h
6,5" x 8,2"27,9" x 1
29 lbs
Related Gas Pressure (PSI)
0.25 up to 0.5 PSI (NG) & 0.4 (LPG)
Gas Type
Liquid Propane Gas or Natural Gas
Activation Flow Rate
Maximmum Flow Rate
2 GPM 3.1 GPM
4.3 GPM
10 PSI 10 PSI 10 PSI
TECHNICAL SPECIFICATIONS
GAS 5L GAS 10L GAS 16L
Gas
Setting
Highest
Lowest
GA5L
GA10L
GA16L
Model
Highest
Lowest
Highest
Lowest
0.5
GPM
1.0
GPM
1.5
GPM
2.0
GPM
2.5
GPM
2.7
GPM
3.0
GPM
3.5
GPM
4.0
GPM
4.3
GPM
129º
34º
-
68º
-
88º
64º
17º
100º
34º
143º
44º
43º
11º
67º
23º
95º
29º
32º
9º
50º
17º
71º
22º
-
-
40º
14º
57º
18º
-
-
37º
13º
52º
16º
-
-
30º
9º
48º
15º
-
-
-
-
41º
13º
-
-
-
-
36º
11º
-
-
-
-
33º
10º
*Highest gas setting: set for Winter/High
*Lowest gas setting: set for Summer/Low
TEMPERATURE INCREASE PER GPM