Mark BASETHERM 06 29 190 - General Information; All Rights Reserved; General Warnings; Product Application

1.0 General
1.1 All rights reserved.
The manufacturer has a policy of continuous product improvement and reserves the right to make
changes to the specications without prior notication. While the technical details are considered
to be correct, they may not form the basis for a contract or warranty. All orders are accepted
subject to our standard terms and conditions of sale and delivery (which will be sent to you at
your request).
1.2 General warnings.
The system must comply with the relevant local and/or national regulations. You must therefore
have the BaseTherm installed by a professionally qualied installer in accordance with all applicable
national and international legislation and regulations. Faulty installation, adjustment, alteration,
maintenance activity or repair shall render the warranty void.
1.3 Application.
The BaseTherm is a room thermostat with an internal room sensor that can be used to control a
bus system for 1 or multiple air heaters up to a maximum of 8 units. The BaseTherm is capable of
controlling heating or ventilation and reporting and resetting faults when they occur.
1.4 Reference to a table or an image.
If reference is made in the manual to an image or table, a number between square brackets is
used, e.g. [3].
The number refers to images and tables at the back of the manual with the stated number.
2.0 Technical specications.
2.1 Technicalspecications.
• Type : BaseTherm
• Product code : 06 29 190
• Connection : Bus system (2-wire)
• Switching differential : 1°C
• Dimensions : 129 x 129 x 20mm (lxwxh)
• Weight : 188 grammes
• Protection class : IP30
• Ambient temperature : 0-40°C
• Temperature setting : 0 to 39°C, in increments of 1°C
2.2 BaseTherm factory settings
• Room temperature setting : 18°C
4