TRANSPORT AND STORAGE
Observe these safety notes to ensure safe storage and transport of this product.
• Always make sure that there is no liquid in the metal housing (otherwise dry the
device and the rope before using it).
• Always store this product in a dry, proper place and keep it away from mechanical
(e.g. sharp edges) or chemical (e.g. acids, gases) hazards, store it at room temperature
and protected from light (UV radiation).
• When drying this product, always put it with the brake drums upwards to avoid
humidity in the housing.
• Store and transport this product in its original (or an equivalent) packaging.
• Check the packaging regularly (holes etc.); especially, if the product is used as an
emergency equipment (= sealed in special packaging).
NOTE
MAINTENANCE
5.1 Repairs
Product changes
Repairs, adjustments or changes to this product that have not been authorized by
MARK Save A Life can lead to severe accidents and falls.
• Changes (e.g. change of the rope length) and repairs have to be performed by MARK
Save A Life.
If you are not sure if this product can be used any more, do not use it but send it to
MARK Save A Life or an authorized partner for inspection.
5.2 Cleaning
• Clean the metal parts with a wet towel.
• Never tumble-dry, never let it dry in the sun or over a heat source.
• Air-dry this product in an airy, shaded place.
• Rinse the rope with warm water and wipe it with a dry towel afterwards.
• Never disinfect the rope.
• Never use chemical detergents.
DANGER
5.3 Disinfection
Disinfection of this product is prohibited. In case of contamination, retire this product
environmentally-friendly.
To Next Page
Loading...
