marposs TS30 90 - Page 2

2
TS30 90° - TOUCH PROBE for TOOL PRESETTING
This product conforms to the EMC requirements, as defined by the directive 2014/30/UE.
Applied Standard: EN61326-1
This product has been designed to be operated in industrial environments; the equipment should
be connected to a SELV type 24 Vdc power supply, as defined by EN60950-1 and NOT to the
mains electrical power supply.
Electrical safety
The product has been manufactured in conformity with the Standard EN 61010-1
Manufacturer
MARPOSS S.p.A.
Address
Via Saliceto, 13 – 40010 Bentivoglio (BO) – Italia
www.marposs.com
Manual code
D4340071G1
Issued by
MARPOSS S.p.A.
UTD MU
Original instruction language
Italian
Issue date
06/2016
Edition
05/2018
The information and descriptions contained in this manual are provided in good faith and
MARPOSS declares that they are accurate at the date of publication. MARPOSS is not obliged
to update the contents or to inform its customers of changes to the product.
The instructions contained in this document are intended for professional users who have a
thorough working knowledge of the product in question. Using the MARPOSS product for any
purpose other than those described in this document, or carrying out any operation on it not
described herein, shall invalidate any and all warranty agreements it may be covered by.
MARPOSS declines any responsibility for losses, damage or claims deriving from incorrect use
of this manual.
This manual, and all the information it contains, are protected under intellectual property rights
legislation.
Marposs acknowledges the rights of third parties whose trademarks or registered trademarks
are referenced in this publication.
Translation from original document
© Copyright Marposs S.p.A. 2018