marposs TS30 90 - Default Chapter; Table of Contents

5
Index
1. STANDARDS AND WARNINGS ................................................................................................ 7
1.1 Description of the manual ..................................................................................... 7
1.2 Original version ..................................................................................................... 7
1.3 Final test and warranty .......................................................................................... 7
2. SAFETY DEVICES ..................................................................................................................... 9
2.1 Product conformity ................................................................................................ 9
2.1.1 Selecting the operator ........................................................................................... 9
2.1.2 Personal protection equipment (PPE) ................................................................. 10
3. GENERAL DESCRIPTION OF THE SYSTEM ......................................................................... 11
3.1 Overall dimensions .............................................................................................. 13
3.2 Technical specifications ...................................................................................... 14
4. INSTALLATION ........................................................................................................................ 15
4.1 Mounting the TS30 90° on the machine table ..................................................... 15
4.2 Mounting the stylus and crash protection pin ...................................................... 16
4.3 Mounting the air blower (if present) ..................................................................... 17
4.4 Aligning the TS30 90° system ............................................................................. 18
4.4.1 Alignment procedure with cylindrical contact ...................................................... 18
4.4.2 Alignment procedure with cubic contact .............................................................. 19
4.5 Electrical connections ......................................................................................... 20
4.5.1 N.O - N.C. Touch connections ............................................................................ 20
5. MAINTENANCE ........................................................................................................................ 21
5.1 Ordinary maintenance ......................................................................................... 21
5.1.1 Cleaning and checks ........................................................................................... 21
5.2 Extraordinary maintenance ................................................................................. 21
5.2.1 Replacing the stylus and/or protection pin .......................................................... 21
6. SPARE PARTS LIST ................................................................................................................ 23