Need help?Do you have a question about the marposs TESTAR E4N and is the answer not in the manual?
General| Brand | marposs |
|---|---|
| Model | TESTAR E4N |
| Category | Measuring Instruments |
| Language | English |
Overview of the E4N column, its features, and connectivity options.
Visual representation and identification of the column's front and rear panels.
Detailed electrical, environmental, and physical specifications of the E4N column.
Dimensions and physical layout of the E4N column for installation planning.
Steps and considerations for physically mounting the E4N column units.
Procedure for connecting the E4N column to the electrical power source.
Method for powering multiple E4N columns connected in series.
Requirements and procedure for connecting air supply for air/electronic modules.
Steps for physically connecting sensor transducers to the E4N column.
How the E4N column performs self-tests and identifies its version/data upon startup.
Overview of different measurement tasks and corresponding programming modes.
Fundamental rules for navigating menus and editing parameters within the E4N column.
Explanation of the keypad functions and navigation within the programming interface.
Step-by-step guide to accessing and leaving the E4N column's programming menu.
Process for changing the display language for menus and messages.
Information on the pre-programmed default settings for various measurement tasks.
Description of the main programming menu with options for channel configurations.
Details on programming basic measurement variables like tolerance and scale.
Configuration of advanced variables including language, communication, and display.
Procedure to reset the E4N column to its factory default programming.
Sets the measurement unit system (e.g., metric, inch) for display.
Defines the acceptable upper limit for a measurement.
Sets the scaling factor for the signal from channel A.
Selects the display language for the E4N column interface.
Configures the column for static or dynamic measurement modes.
Sets the mode for switching between multiple measurements or sensors.
Guide to defining measurement formulas using sensor signal coefficients (K values).
Practical example of programming the E4N for single-sensor outer diameter measurement.
Example demonstrating programming for measuring both inner and outer diameters simultaneously.
Configuration example for measuring the gap between two components using two sensors.
Example illustrating how to program for taper measurement using four transducers.
Step-by-step guide for mechanically and electronically adjusting inductive, HBT, and MRT sensors.
Procedure for adjusting air/electronic sensors using master gauges and control knobs.
Explanation of the roles of the sensitivity and zero adjusters on the air/electronic module.
Process for calibrating measurements using a single master gauge.
Procedure for calibrating measurements when using two master gauges.
Details on the amplifier module for connecting LVDT sensors, including pinouts and versions.
Information on the amplifier module for HBT sensors, covering connectors and signal pins.
Description of the amplifier module compatible with MRT sensors, including its pin configuration.
Overview of the amplifier module designed for air/electronic sensors, including connector types.
General guide for connecting external control devices like pushbutton boxes and footswitches.
Details on the four-button external pushbutton box and its functions in static/dynamic modes.
Information on connecting and using an external footswitch for controlling the E4N column.
Method for connecting external devices to a system of multiple E4N columns.
Description of the Digimatic serial interface for data transfer to analyzers or concentrators.
Information on the analog output interface for transferring measurement values to statistical analyzers or recorders.
Details on the RS232 interface for serial printer or PC connections, including protocol customization.
Configuration and usage of the print mode for transmitting measurement data via RS232.
List of available spare parts, power supply cables, and their part numbers.
General category for additional accessories and cables for the E4N column.
List of various cables for connecting different modules and devices to the E4N column.
Specific accessories including pushbutton boxes and footswitches for remote control.
Specialized accessories designed for the E4N column's air/electronic modules.
List of available user and programming manuals for the E4N column in different languages.
To Next Page
