marposs TESTAR E4N - CALIBRATION PROCEDURE; CALIBRATION OF ONE OR MORE MEASUREMENTS, EACH WITH ONE MASTER; CALIBRATION OF ONE OR MORE MEASUREMENTS, EACH WITH TWO MASTERS

68
5
PROG
CAL
ENTER
+25.0
PROG
CAL
ENTER
+16.5
A
AIR
PROG
CAL
ENTER
-58.0
PROG
CAL
ENTER
-16.5
A
AIR
PROG
CAL
ENTER
--------
PROG
CAL
ENTER
+16.5
A
AIR
Step 6: Remove the Min. master and insert the Max. master in the measuring position again.
Step 3: Insert the Max. master in the measurement position. Turn the sensitivity adjuster until the value
shown on the alphanumeric display is close to
Step 4: Remove the Max. master and insert the Min. master in the measuring position.
Step 3
Step 5:
Step 7: Turn the sensitivity adjuster until the value shown on the alphanumeric display is close
(Upper limit).
Step 8: Remove the Max. master and insert the Min. master in the measuring position again.
Step 7
Step 5
ADJUSTMENT PROCEDURE