marposs TESTAR E4N - PARITY= (Parity BIT); HAND-SH= (Synchronizing); Linxpag= (Number of Data Lines Per Print-Out Page)

43
3.9.15
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
3
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
3.9.17
3.9.16
PARITY= (Parity BIT)
Step 1: Press the ENTER key to set the variable.
Step 2:
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
PARITY=
Step 1
none
Step 2
Step 3
none
odd
even
even
Step 1: Press the ENTER key to set the variable.
Step 2: 
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
hardware
Step 3
The "HAND-SH=" variable specifies the synchronising mode used between the E4N column and external devi-
ces.
HAND-SH=
Step 1
none
Step 2
none
hardware
Xon / Xoff
HAND-SH= (Synchronizing)
HOW TO PROGRAM THE E4N COLUMN
LINxPAG= (Number of data lines per print-out page)
LINxPAG=
Step 1
20
Step 3
Step 1: Press the ENTER key to set the variable.
Step 2: 
digit is flashing). Use the UP and DOWN arrow keys to increase or decrease the value
of the flashing digit.
Note: Not to program (Reset) the variable, repeatedly press the UP or DOWN arrow key when
the first digit on the left of the display is flashing.
Step 3: Press the ENTER key to confirm the numeric data and to pass to programming of the
next variable.
Step 2
30
20
R_