marposs TESTAR E4N - PROGRAM: MENU; MEASURE: MENU

19
3
3.6.1
3.6.2
PROG
CAL
ENTER
PROG
CAL
ENTER
+0030.0
PROG
CAL
ENTER
-0030.0
PROG
CAL
ENTER
R____._
PROG
CAL
ENTER
R____._
PROG
CAL
ENTER
±100.0
PROG
CAL
ENTER
-1.000
PROG
CAL
ENTER
R____._
PROG
CAL
ENTER
+0000.0
PROG
CAL
ENTER
R____._
HOW TO PROGRAM THE E4N COLUMN
The main menu "PROGRAM:" contains three programming options:
- one ch.
- two ch.
- all
(programming for one transducer)
(programming for two transducers)
(programming for a maximum of four trasducers)
"PROGRAM:" MENU
The "MEASURE:" menu is used to program the basic variables for the measurement to be carried out.
(Measurement system)
(Upper tolerance limit)
(Lower tolerance limit)
(Upper tolerance approach limit)
(Lower tolerance approach limit)
(Scale)
(Multiplication coefficient for channel A signal)
(Measurement nominal value)

(Deviation from master gauge 2)
metric
Default values:
"MEASURE:" MENU

VALUE
PROGRAM:
two ch
one ch
all ch
TOLER+=
TOLER-=
APPROCH+=
APPROCH-=
SCALE=
K.CH.A=
ABSOLUT=
MASTER1=
MASTER2=
M.SYST=
MEASURE: