marposs TESTAR E4N - LANGUAG= (Language)

37
3.9
3.9.1
3.9.3
3.9.2
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
3
30 n.r.
60 n.r.
125 n.r.
250 n.r.
500 n.r.
1000 n.r.
625 w.r.
1250 w.r.
2500 w.r.
5000 w.r.
HOW TO PROGRAM THE E4N COLUMN
VARIABLES IN THE "ADVANC.:" MENU
LANGUAG= (Language)
LANGUAG=
Step 1
Step 1: Press the ENTER key to set the variable.
Step 2: 
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
italiano
Step 3
english
Step 2
english
francais
deutsch
espanol
italiano
Step 1: Press the ENTER key to set the variable.
Step 2:
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
SENS. A= (Sensitivity correction coefcient)
Step 1: Press the ENTER key to set the variable.
Step 2: 
DOWN arrow keys to increase or decrease the value of the flashing digit.
Note: Not to program (Reset) the variable, repeatedly press the UP or DOWN arrow key when the first digit on the left of the
display is flashing.
125 n.r.
W.R. A=
Step 1
Step 2
125 n.r.
Step 3
n.r. 
w.r. 
W.R. A= (Working range assigned to channel A)
SENS. A=
Step 1
Step 2
Note: To program the variable "W.R.B=" "W.R.C=" "W.R.D=" follow the same procedure.
+1.000
-1.000
R_.___