marposs TESTAR E4N - PASS= (Programming Password); LUMIN= (Scale Brightness)

45
3.9.20
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
3
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
3.9.21
0123
PASS=
1000
0000
R___
Step 1: Press the ENTER key to set the variable.
Step 2: 
digit is flashing). Use the UP and DOWN arrow keys to increase or decrease the value
of the flashing digit.
Note: Not to program (Reset) the variable, repeatedly press the UP or DOWN arrow key when
the first digit on the left of the display is flashing.
Step 3: Press the ENTER key to confirm the numeric data and to pass to programming of the
next variable.
PASS= (Programming password)
Step 2
Step 1
Step 3
HOW TO PROGRAM THE E4N COLUMN
LUMIN= (Scale brightness)
Step 1: Press the ENTER key to set the variable.
Step 2: 
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
LUMIN=
Step 1
normal
Step 2
normal
high
low
normal
Step 3