marposs TESTAR E4N - K.CH.A= (Multiplication coefficient for the channel A signal)

26
3
3.8.8
3.8.7
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
PROG
CAL
ENTER
Step 3: Press the ENTER key to confirm the numeric data and to pass to programming of the
next variable.
Note: The maximum and minumum values that can be set are the same as the pro-
grammed upper and lower tolerance limits (see Sections 3.8.3 and 3.8.4).
HOW TO PROGRAM THE E4N COLUMN
K.CH.A= (Multiplication coefcient for the channel A signal)
This variable defines the full scale range shown on the LED scale.
Step 1: Press the ENTER key to set the variable.
Step 2: 
Step 3: Press the ENTER key to confirm the table data and to pass to programming of the next variable.
K.CH.A=
Step 1
Step 2
-0025.0
Step 3
SCALE= (Measurement scale display)
SCALE =
Step 1
+/-0.005
Step 2
+/-0.005
Step 3
Note: If SCALE=auto is programmed, the system automatically calculates the range value of the analog bar scale
based on the programmed values of the tolerance limits. The tolerance center is always positioned in the
central led of the analog bar scale and the tolerance limits are positioned symmetrically with respect to the
tolerance center.
-1.000
+1.000
R_.___
±0.005

±0.025
±0.050

±0.250
±0.500

±2.500
±5.000
auto
±5.000

±25.00
±50.00

±250.0
±500.0

±2500
±5000
auto
-
±0.0005

±0.0025
±0.005

±0.025
±0.050

±0.250
auto
±0.250
±0.500

±2.500
±5.000

±25.00
±50.00

±250.0
auto
±250.0
±500.0

±2500
±5000
-
-
-
-
-
auto
FULL SCALE RANGE VALUES BY UNIT OF MEASUREMENT
mm
micron inch  