marposs TESTAR E4N - CONNECTIONS TO THE MAINS POWER SUPPLY OF A GROUPS OF E4 N COLUMN

9
2
B
A
B
A
2.3
INSTALLATION AND USE
CONNECTIONS TO THE MAINS POWER SUPPLY OF A GROUPS OF E4N COLUMN
E4N columns can be mounted singly or in groups of
up to 5 units on a single stand.
Groups of E4N columns must be connected to each
other in series using the power jumper cables (B). To power up
a group of columns, switch on the power supply switch of the
module connected to the mains. The power supply switches of
the other modules must be in the ON position and should be
