60
4
4.5
PROGRAMMING EXAMPLES FOR THE E4N COLUMN
EQUIPMENT REQUIRED:
TWO FOUR-CHANNEL E4N COLUMNS
ONE MANUAL BENCH GAUGE TYPE MARPOSS QUICK SET
FOUR PENCIL PROBES TYPE MARPOSS RED CROWN
FOUR SIGNAL SPLITTING CABLES
On the programming data sheet the parameters for which a value
must be programmed are shown in bold type.
The programming data sheet also shows the default values.
Variable data not shown are not part of this measurement example and can be
ignored.
DATA:
EXTERNAL DIAMETER VALUE = 60.000 mm +/- 0.030
TAPER MEASUREMENT WITH FOUR TRANSDUCERS
To Next Page
Loading...
