Marquant 005-069 - Addition to Weighing Result; MEASURING DATA

EN
37
– The measurements can be
misleading after intensive exercise,
excessive slimming or severe
dehydration.
ADDITION TO WEIGHING RESULT
When the display has stabilised it is possible
to add extra weight – for example to weigh a
small child. Each addition must weigh more
than 2 kg for a new weighing.
Weighing a small child
1. First weigh yourself. The digits ash
to show that the weighing result has
stabilised and locked.
FIG. 6
2. Lift up the child without getting o the
bathroom scale.
3. Now weigh yourself and the the child,
without getting o the bathroom scale.
This gives you a value for the total weight.
FIG. 7
4. Deduct the rst weighing valve from this
total to get the weight of the child.
MEASURING DATA
Measurement of body fat percentage/water
content/muscle percentage/ bone percentage/
calories.
Standard parameters
The following standard parameters are set the
rst time the scale is started:
User
number
Gender Height Age
1 Female 165 cm 25 years old
The following range of settings can be made
for the dierent parameters:
User
number
Gender Height Age
1-12
Male/
Female
100-250
cm
10-100
years old
Parameter settings
Example: Setting of parameters for user 3,
female, 168 cm, 28 years old.
1. Press SET to start.
2. Standard parameters are shown.
3. Press to select required user number.
4. Press SET to conrm and go to next
parameter.
5. Press to enter gender.
6. Press SET to conrm and go to next
parameter.
7. Press to enter height.
8. Press SET to conrm and go to next
parameter.
9. Press to enter age.
10. Press the platform.
11. The display shows 0.0.
12. The scale switches o automatically after
a few seconds.
FIG. 8
NOTE:
• If no settings are made for 6 seconds the
settings will be stored automatically and
the display shows 0, which indicates
that measuring of body fat percentage is
activated.
• If the display shows 0 under parameter
settings, press SET for 3 seconds to
activate settings mode and make the
required settings.