Marshall Amplification CV630-NDI - Chapter 7 DIP Switch Settings; DIP Switch Overview; Output Switch Settings; IR Select Settings

Marshall
Chapter 7 DIP Switch Setting
7.1 DIP SWITCH
7.1.1 OUTPUT Switch
To switch via the OSD/ RS-232 Command is also available based on the last
executed action
7.1.2 IR SELECT
ID
Setting
1
2
3
ID
Resolution
Frame Rate
0
3840x2160p
29.97
1
25
2
1920x1080p
59.94
3
50
4
29.97
5
25
6
1280x720p
59.94
7
50
8
29.97
Not Supported
9
25
A
1920x1080i
59.94
B
50
C
Reserved Reserved
D
E
F
Marshall
Chapter 8 Troubleshooting
This chapter describes problems you may encounter while using CV630-NDI If you have
questions, please refer to related chapters and follow all the suggested solutions. If the problem
still occurred, please contact your distributor or the service center.
No.
Problems
Solutions
1.
Boot without power
signal
1. Make sure you have plugged in the power cord.
2. When using a PoE connection, ensure that the power supply
supports POE+ (IEEE 802.3at) hubs
2.
There is no image
output from CV630-NDI
1. Check the power supply or PoE supply functions.
2. Confirm the output signals are in streaming output.
3. Confirm whether the camera resolution can be used together
with the monitor equipment
 If 4k output, confirm the monitor equipment supports 4K
output
4. Replace the cables and make sure they are not faulty.
3.
CV630-NDI image is
severely delayed
Please use 1080p or 720p 60/50 fps rather than 25/30 fps
signals.
4.
RS-232 cannot be
controlled
1. Confirm the connection is correct (RS-232 In/ Out)
2. Please make sure the Baud rate setting is the same as the
control equipment
5.
No image for 3G-SDI
output resolution
3840x2160 29.97/ 25
Please confirm the screen menu/ Dip Switch setting
3G-SDI supports output resolutions up to 1080p 59.94/50
6.
Whether the Internet
can be used for
operation
Please refer to Chapter 6 Network Function Description for
the Internet usage
CV630-NDI Manual
www.marshall-usa.com45 46