007
BACK TO INDEX
WOBURN III - FULL ONLINE MANUAL
INSTRUCTIONS ENGLISH
CONNECTING A TV WITH HDMI
I. Plug an HDMI lead into the HDMI port on the back of Woburn III and the
HDMI ARC port on your TV.
II. Turn on the speaker and use the source button to select HDMI.
III. Turn on your TV and select HDMI ARC audio output and choose PCM
(2-channel) as format.
If Woburn III is powered on and connected to a TV, turning on the TV will
auto-select HDMI as source.
Note: HDMI leads are not included.
For information about your TV’s HDMI support, labelling of ports and user
instructions, please consult its user manual.
NETWORK STANDBY MODE
Woburn III will go into network standby if left unused for 10 minutes to save
energy. Any connected Bluetooth device will be disconnected.
Interact with any control or button on the top panel, reconnect a Bluetooth
device or play anything via the physical inputs to wake up the speaker.
PERFORMING A FACTORY RESET
A factory reset will return the speaker to its original settings, excluding any
firmware updates.
Note: This will delete all user settings and the speaker needs to be set up again.
I. Push and hold the media control for more than 10 seconds and the
speaker will reset.
II. Remove WOBURN III from your audio device’s Bluetooth list before
pairing again.
MARSHALL BLUETOOTH APP
Download the Marshall Bluetooth app to get the most out of your speaker
and keep it up to date with the latest software.
To Next Page
Loading...
Need help?
General
