Marshall Electronics VS-102-HDSDI - Page 38

VS-102-HDSDI User Manual
IP Server Instruction Manual
38/61
 Local & Remote Event Configuration
 The Event Configuration configures the actions for each event type. The Local section configures
the actions for events from the local (self) system, and the configuration activates local devices.
Remote sections configure the actions for events from the remote (peer) system.
 The following table lists the possible actions for events:
Action
Description
Beep
Outputs beep sound using the buzzer in the
system
Alarm1/Alarm2
Triggers alarm (relay) port.
E-mail
Sends E-mail to the specified address. AVI file
can be attached
FTP
Upload AVI file to a specified FTP server
Preset
Moves the PTZ to associated preset position
 The Sensor1 / Sensor2 / Sensor3 / Sensor4.
Configures the actions when the sensor is activated. Multiple actions can be set for a single
event.
 On Video Loss
Configures the actions when the video input signal is lost. Multiple actions can be set for a single
event.
 On Motion
Configures the actions when motion is detected. Multiple actions can be set for a single event.
 On Disconnect
Configures the actions when the link (connection) with peer system is disconnected. Multiple
actions can be set for a single event.
 Alarm and Beep activation duration
 Sets the duration of the alarm or beep activation in case of an event. If it is set to "continuous", it will
be in an active state until an operator resets it manually.